Paper Piano

Paper Piano

You can extend the alligator clip wires by connecting to other conductive materials. Copper tape is a good conductor and is easy to work with.

materials:

– construction paper

– copper tape

– Sound Clippys Board

– alligator clips

IMG_2412

To build a successful “piano” we need to be able to connect the digital pins to ground individually. This will be done by cutting individual “keys” into the paper which will become the triggers or buttons.  First its good to decide on the size and cut the basic shape. I’m going to make a basic rectangle piano with 6 keys.

Basic Design

Cut down to size and figure out how the “buttons” will be made. For this simple example I cut the construction paper to a small rectangle about 6″ x 3″, then I folded it in half the long way so it is now 6″x1.5″.

IMG_2413

Cut the individual keys

IMG_2414

Run the ground “wire”

All the keys need to be able to connect to ground (GND). Since all the keys are in-line I just need to run one long piece of copper tape which will go under all of the keys.

Keep the tape a little longer than it needs to be so it can be folded around the back. This makes for a better surface to connect to with the alligator clips later.

IMG_2416

Now run copper tape for each individual key. Make sure that the tape is long enough to fold around to the back side of the key where it will make contact with the GND copper tape.

IMG_2418

IMG_2419

Connect

Connect the GND to the ground copper tape which runs under all the keys.

Connect the individual keys to the desired digital inputs.

The example patch “simple-synth” makes each digital input control a different pitch to be played.

The fun has just begun!

Try other examples in the sound clippys example folder to explore different sounds and ways of using digital inputs.

Leave a Reply

Your email address will not be published. Required fields are marked *